Sonicview Setup Tutorial

Default How to program SV1000 from scratch to get it up and going
1. Ensure your using a null modem cable and it is hooked up at both ends and your serial port is open in your computer Bios
2. Your unit is plugged into an outlet and turned off at the rear of the unit

Part B:

1. Download fresh copy of loader, factory bin and current running bin.
2. Place all files in the same folder as loader is located.

Part C:

1. With SV1000 turned off at the back, start loader program
2. Click STB -> Connect Config for Com 1
3. Click STB -> Download file (PC->STB) directing the downloader to the file you are wanting to load.
4. Window appears entitled Data Transfer -> Turn VS1000 on from the rear power button and do not touch it until transfer is complete and SV1000 reboots.
5. Turn off SV1000 at rear, disconnect null modem cable
6. Setup on TV and turn on -> configure, scan satellites and watch TV once autoroll kicks in
7. Autoroll can take up to ten minutes the first time. Until the keys roll you will have a black screen and red message No Service or Scrambled appearing. Do not panic, have faith. if after ten minutes no video, hard boot from rear once and video should come in. other option is manual loading keys

When loading load the factory bin, current bin, satinfo, channel lists in that order when required.

Credit: valiant

Default How to setup your antenna correctly for 110/119
Use your remote control to enter the antenna setup menu:
MENU > INSTALLATION > ANTENNA SETUP

If you are using legacy LNBs, you need to use the following setup:

Satellite:———-
LNB Power:————ON
LNB Type:———–SINGLE
LNB Frequency:——11250
Transponder: ——–12239 (any tp on that sat)
22KHz:—————OFF
Search Option:——-ALL
Network Search ——On
DiSEqC:————-Port1
Motor: ————-Disable
Legacy Switch:——-Off

Satellite:———
LNB Power:———– ON
LNB Type:———–SINGLE
LNB Frequency:——11250
Transponder:——– 12224 (any tp on that sat)
22KHz:—————OFF
Search Option:——-ALL
Network Search ——On
DiSEqC:————-Port2
Motor: ————-Disable
Legacy Switch:——Off

If you are using a DP LNB, then you need to use the following setup:

Satellite:———-
LNB Power:————ON
LNB Type:———–OCS-DP
LNB Frequency:——11250
Transponder: ——–12239 (any tp on that sat)
22KHz:—————OFF
Search Option:——-ALL
Network Search ——On
DiSEqC:————-Port1
Motor: ————-Disable
Legacy Switch:——-Off

Satellite:———
LNB Power:———– ON
LNB Type:———–OCS-DP
LNB Frequency:——11250
Transponder:——– 12224 (any tp on that sat)
22KHz:—————OFF
Search Option:——-ALL
Network Search ——On
DiSEqC:————-Port2
Motor: ————-Disable
Legacy Switch:——Off

Credit: merog